Although clobetasol propionate cream may be used on the scalp, clobetasol propionate foam or solution is much more convenient and better tolerated on the scalp.
To apply clobetasol propionate foam, wash your hands and invert the canister, then dispense a small amount of foam (up to a golf-ball-sized dollop as a maximum) onto a saucer (this allows you to see exactly how much you are dispensing) or directly onto the lesion, taking care to avoid the eyes. Do not dispense directly onto your hands.
If you have dispensed the foam onto a saucer, pour the foam from the saucer onto the lesion, otherwise use clean, dry fingertips to gently massage the foam into the affected area. Repeat this process until the area needing treatment is covered with a thin layer of foam.
If the foam seems too runny or the canister seems warm to the touch, place the canister under cold running tap water to cool it down.
The foam is flammable, so avoid exposure to flames or smoke during and immediately after application. Wash your hands immediately after massaging the foam into your scalp.
Once the skin condition has been treated, application should be decreased to the minimum necessary to achieve control and avoid relapse. Discontinue clobetasol if possible.
Clobetasol propionate may be used to treat eczema, psoriasis, or other steroid-sensitive rashes that occur on the scalp. Because it is classed as a super potent steroid, treatment courses should not exceed two weeks and no more than 50ml or 50mg of clobetasol propionate should be used over one week.
How do you use clobetasol propionate solution on your scalp?
To apply clobetasol solution, pour a small amount of solution directly from the bottle onto the scalp, but only enough to cover the lesion. Avoid contact with the eyes.
Rub the solution in with your fingers and allow to dry before wearing a hat or brushing your hair. Wash your hands immediately afterward.
How do you use clobetasol propionate cream on your scalp?
To apply clobetasol propionate cream to your scalp, soak or wash the affected area to remove any scales. Dry with a towel, then apply a small amount of cream to the affected area and rub gently into the lesion. Apply a little bit more and rub in again, then cover the area with a thin piece of plastic film and seal it using adhesive tape to the adjacent skin or wrap in place with a gauze or elastic bandage.
Although the manufacturer of clobetasol states that clobetasol should NOT be used with occlusive dressings, under a doctor's advice, a covering may be used on the scalp to enhance efficacy and reduce mess.
How do you use clobetasol propionate shampoo?
If you are using clobetasol propionate shampoo, use it as you normally would use a shampoo but leave it on your scalp for 15 minutes before rinsing out. Avoid contact with the lips and eyes.